Divide the amount in the vial by the dose, in the same unit. A 10 mg vial divided into 2 mg amounts holds 10 ÷ 2 = 5 doses. The water you add does not change the count; it only changes how many units each dose takes.

The amounts below are arithmetic examples, chosen as round numbers. They are not suggested doses. Your dose comes from your prescriber or your instructions.

The formula

Doses in a vial = amount in the vial ÷ dose, with both in the same unit. Convert first if they differ: 1 mg = 1,000 mcg, so a 5 mg vial is 5,000 mcg, and 5,000 ÷ 250 mcg = 20 doses. The mcg to mg converter does the conversion.

Count whole doses only. 10 mg ÷ 3 mg is 3.33, which means 3 full doses and 1 mg left over. The leftover is not a fourth dose.

To turn doses into time, divide by how many doses you take per week. Ten doses taken once a week last ten weeks; taken daily, they last ten days.

Example table (arithmetic only)

Whole doses per vial for a range of example amounts in mg. A dash means the amount is more than the vial holds.

Vial0.25 mg0.5 mg1 mg2 mg2.5 mg5 mg
5 mg201052 (2.5)21
10 mg402010542
15 mg6030157 (7.5)63
20 mg8040201084
30 mg120603015126
60 mg24012060302412

Where the division leaves a part dose, the exact figure is in brackets. A 5 mg vial holds 2.5 amounts of 2 mg: two whole doses and 1 mg left.

For amounts written in mcg:

Vial100 mcg250 mcg500 mcg
5 mg (5,000 mcg)502010
10 mg (10,000 mcg)1004020

These counts were produced with the calculators’ own code, which also rounds down to whole doses.

Why the water does not matter here

Water spreads the vial’s contents through a volume; it adds nothing and removes nothing. A 10 mg vial mixed with 1 mL holds 10 mg in 1 mL, and with 3 mL it holds the same 10 mg in 3 mL. Each dose is a different number of units in the two cases, but the count of doses is the same. The bacteriostatic water article shows how the units change.

Labelled vials count doses for you

Branded multi-dose products state the count on the label. The Zepbound prescribing information says: “The multi-dose vials and single-patient-use KwikPen each contain 4 doses”.[1] Each multi-dose vial holds 2.4 mL, used as four 0.6 mL doses.[1]

The label also sets the end point by count and by time. Section 16 says to throw away an opened multi-dose vial or KwikPen “after a total of 30 days at room temperature, 30 days after first use, or after taking 4 weekly doses, even if there is medicine left in it.”[1] For the KwikPen, the Instructions for Use add: “Do not inject the leftover medicine.”[1] So for a labelled product, the count on the label is the plan, whatever liquid remains. The Zepbound and Mounjaro vial article has the full label table.

The count is a maximum

For a vial you mix yourself, the division gives the most the vial can supply if every draw is exact. Real draws are not always exact, so the number of doses taken from a vial can come out lower than the count. If a draw comes up short, the pharmacy that supplied the vial is the one to ask.

Check your own vial

The tirzepatide calculator below is preset with a 10 mg vial and 2 mL. Type the dose written in your instructions and the result includes the number of doses in the vial.

Vial sizes
As printed on the vial label.
Water volumes
Bacteriostatic water, in millilitres.
As written in your instructions.
Dose unit
Syringe (U-100)

Result

Calculated

Enter your dose and press Calculate.

Concentration: 5 mg/mL

The drawing is an illustration of the arithmetic. Always read the printed scale on your own syringe.

Show the working

The working appears here after you press Calculate.

“≈” marks a value rounded for display. Working each line by hand from the numbers shown gives the same result.

Nothing you type is stored or sent anywhere. The arithmetic runs in your browser.

Next step

Now make sure you take it.

Kept reminds you when each dose is due and logs it in one tap.

Set my reminder in Kept
Illustration, not a screenshot.

Arithmetic only. This is educational arithmetic, not medical advice. Check every number against your vial label and your clinician's or pharmacy's instructions.

Kept

Scan to get Kept

Point your iPhone camera at the code.

Open the App Store

Full page: Tirzepatide calculator, with units charts and worked examples.

The dose volume calculator does the same for any compound, and the compound pages, such as retatrutide and BPC-157, show the count for each vial size.

Tracking what is left

Knowing a vial holds ten doses only helps if you know how many you have taken. Count down as you go: on paper, the printable dose log has a box for each vial’s start date and amount. Kept, a paid iPhone app, does the counting for you: each dose you log comes off your supply, and it warns you when the supply runs low, so the reorder happens before the vial is empty.

Mounjaro, Zepbound and KwikPen are registered trademarks of Eli Lilly and Company. Kept is independent and not affiliated with, endorsed by or sponsored by Eli Lilly and Company.